Technical Forums» Technical / Performance» bigger flywheel(Frank)

Rudy
» CMF Member

Hunter Valley mob 0400767960
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Frequent posterFrequent posterFrequent posterFrequent posterFrequent poster

bigger flywheel(Frank)

 Sat 03 Jan 2015 07:10:26 PM
I remember reading once that a bigger flywheel from one of the smaller GA motors 13/14de? fits the cg13de, can anyone or Frank confirm this and tell me what cars were these fitted to, so I can check the weight, and the end result will be to use a bigger clutch, LSD gearbox before getting a new motor reconditioned.
Any advice peoples?
frank2
» CMF Member

birmingham
United Kingdom

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Forum addictForum addictForum addictForum addictForum addict

Re: bigger flywheel(Frank)

 Sat 03 Jan 2015 11:08:36 PM
GA16 rudy, baguete used an alloy fidanza one that i posted up some measurements etc.
the centre bore is slightly bigger btw
http://www.micra.com.au/community/message.php?messageid=67714
m-hayes
» CMF Member


United Kingdom

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
New to forumNew to forumNew to forumNew to forumNew to forum

Re: bigger flywheel(Frank)

 Mon 05 Jan 2015 05:41:48 AM
Hi - After fitting I dogbox, I managed to break the standard clutch (spring jumped out). I've fitted a 1400 Almera clutch which seems much beefier and went straight in. I did read somewhere the Nissan works cars did the same thing.