|
Micralife » CMF Member Sydney Australia Member since:  Posts:  |
Rims. |
Thu 11 Jul 2013 09:15:34 AM |
|
Hi I've just purchased some Steelies and the centre bore is to small. If I machine the centre bore bigger will it weaken the wheels in any way?
Thanks Micralife |
||
|
|
||
|
frank2 » CMF Member birmingham United Kingdom Member since: Posts: |
Re: Rims. |
Thu 11 Jul 2013 05:51:46 PM |
|
to some degree yes, what wheels mate ?
|
||
|
AB-NRML » CMF Member Perth Australia Member since: Posts: |
Re: Rims. |
Thu 11 Jul 2013 10:23:31 PM |
|
What about fitting a 5mm spacer to get around that problem?
|
||
|
Micralife » CMF Member Sydney Australia Member since: Posts: |
Re: Rims. |
Fri 12 Jul 2013 05:54:00 AM |
|
frank2 WROTE: "to some degree yes, what wheels mate ?" They are just stock steel rims. I would only have to machine out 2-3mm max, it's just enough to be a pain in the but. |
||
|
Micralife » CMF Member Sydney Australia Member since: Posts: |
Re: Rims. |
Fri 12 Jul 2013 05:54:42 AM |
|
AB-NRML WROTE: "What about fitting a 5mm spacer to get around that problem?" I'm not too sure how spacer work.. |
||
|
frank2 » CMF Member birmingham United Kingdom Member since: Posts: |
Re: Rims. |
Fri 12 Jul 2013 06:09:05 AM |
|
Micralife WROTE: They are just stock steel rims. I would only have to machine out 2-3mm max, it's just enough to be a pain in the but." i ground 2mm from my dub wheel centre,s np, with an angle grinder and a well worn stone :) |
||