PCD 100 to PCD 114

need help guys...

has anyone tried converting the micra from pcd 100 to pcd 114 to fit those old school deep dish rims?


Rims are 13x8s pcd 114. not quite sure about the offset but im pretty sure its about +14 something..

thanks...

I have a set if 13s in 4/100 for sale with a offset of +13 if you want to buy them.


But to answer the question I am sure someone would have done it at some stage. You would think it would be pretty easy to do by either swapping over to a whole new hub setup from another vehicle or getting them re- drilled etc.

n16 front hub perhaps? not sure what will fit for the back... thanks guys. sikk i live in the philippines and shipping would cost much...
:(

Your easiest option would be to get a set of hub adapters. They're not made for specific models but instead, specific PCDs. They'll probably be 25MM and look and function the same as bolt-on spacers but the PCD the wheel bolts onto will be different to the PCD of your hub.

You wouldn't bother getting them from Australia - Japan would be your easiest option (Yahoo Auctions or similar). There's also places like this which would make up a set to your specs and would probably send them overseas, too.

You would definitely want to get hub-centric adapters, meaning that it matches your hub diameter so the spacer isn't putting all of its load onto the studs.

Just remember, if your wheels are +14 and you get spacers that are 25MM thick, your effective offset from the hub will be -11 and with 8J wheels, you're definitely going to need some bolt-on flares.

---dens

Yeah. Convertes ftw. They sell 15mm wide ones on yahoo. Only prob being so thin is that they run half nuts and u have to cut the studs down to have clearance for older type rims aka ssr mk1 2 3's etc.

Anyone been able to find a set of hubcentric spacers for 4x100 to 4x114.3 yet? I can't it >.<

are the micra thread size 1.5 or 1.25? sorry a bit off topic

EDIT: Ebay hubcentrics are either 1.5" thick or 2" thick.. thats abit too much isnt it?

If they're not hub-centric you can get hub rings on ebay to make them fit around the hub. I imagine it would be quite hard to find the right hub diameter, spacer thickness and the right PCDs all in the one thing. Like said, you'd almost be better of getting them custom-made :P

---dens

http://fifteen52.us/shop-2/#ecwid:category=451682&mode=product&product=1553204

look ^^^ this place has it done for you, pick the right measurements and supply the money :P

On a serious note, has anyone done a 4 x 114 conversion please PM me.

Why is everyone new on here so keen for this! It does not work with out modding your hubs or buying converters!

i dont get why the need to, theres so many decent 4x100 rims that are copys of the old school just got to look.

when i had a car with 4x114.3 for the life of me i couldnt find anything i liked everything was 4x100 lol

for decent japanese wheels 4x100 are hard to come across in good sizes, whereas there are a heap in 4x114.3, i paid a premium for all mine simply because they were 4x100 but hey each to their own!

Anyone got or used conversion spacer adapters?

Im getting a set of 4 x 100 to 114 in the next few days

Hope they aren't eBay ones

Whys that? had bad exp with them?