dyno at last

finally got a dyno done on my car

and the result was 92.4kw front wheels

woo thats what i expected

Mate that is s-moookin'!

Unreal congrats.

Slam up the graph in the dyno rangers section!

Whoaaa ! Another forced Micra ready to spread fear and terror !!
Well done Aaron.
Go smoke em mate.

there was this swift there too running 15psi on a t25 that got 148kw..

shouldve seen the power graph..it just went up..haha didnt even rev for long..like about 3 seconds it sounded

ive added it to our dyno page too.

great looking graph that is, 92.4...wow...congrats

Thats on 8psi too isn't it Aaron?

Cisco, does your controller spike?

Well done Aaron, thats a damn nice figure. After I sort out my spiking I'll be sure to hit the dyno on high/low boost settings!

Sean

gauge was out a bit and reads 8 but map sensor on ecu shows 7.

i think 7..

im tempted now once you know how much you make you want MOREEE

Its a drug Aaron. After a while you will get used to that sort of boost and think gee wish I had more.
Dark side has got you mate well and truly.

Nice smooth graph shape aswell Aaron. Shows that it would be driving nicely.

That swift did awesome off 15psi/T25. Did he have an LSD? Sounds like it would scream.

Nah mighty. When it peaks at 15.5psi (like now on high setting), that's as high as it gets, i.e. it doesn't spike to 19 before and then settle back down to 15.5 etc.
Same for low setting at 11psi, it doesn't spike above 11 before settling back to 11.

But I can't adjust it to any lower than 11psi at the moment. Will sort that out whenever the time comes when my car gets fixed and put back on the road.

Hrrmm only 7spi?! Damn thats a REAL nice figure for that boost

Hey Cisco... My controller spikes at the moment (ie. to run a constant 10psi I have to hit 1.0bar for ~1/2 seconds before it settles down... no good) So I might have to invest in a new controller, I think my solenoid is stuffed.

Also.. Without getting a new actuator you might not be able to run lower boost than 11psi. If you want, I have a T25G 7psi actuator you can have.

Seano

Hmm cool thanks mate. Yeah I was wondering if it might be just the boundaries of my current actuator.

I also have that turbosmart stage-1 boost controller just sitting here too (the one removed from my car). If you want to install it for now just to run a constant boost level while you haven't got your new one, you can have that aswell. Works perfectly. Maybe we should do a trade :) heh.

I see. yeah a spike's a bit risky isn't it.

Hmm I might take you up on that mate!

You'll be hearing from me soon!

Seano